Digitální knihovnaUPCE
 

Fabrication of TiO2 nanotubes on Ti spheres using bipolar electrochemistry

ČlánekOtevřený přístuppeer-reviewedpostprint
Náhled

Datum publikování

2020-01-24

Vedoucí práce

Oponent

Název časopisu

Název svazku

Vydavatel

Elsevier

Abstrakt

In this work, the anodization of Ti spheres using bipolar electrochemistry is reported for the first time. TiO2 nanotubes were found over the entire surface area of the Ti spheres when a square-wave potential was employed. The TiO2 nanotubes were ∼77 nm in inner diameter and had a thickness of ∼2 µm on the extremities of the Ti spheres. Due to their increased surface area, the Ti spheres covered with TiO2 nanotubes had a rate constant for the photocatalytic degradation of methylene blue which was approximately 2.15 times higher than that of non-anodized Ti spheres with a thin thermal oxide layer.

Rozsah stran

ISSN

1388-2481

Trvalý odkaz na tento záznam

Projekt

EC/H2020/638857/EU/Towards New Generation of Solid-State Photovoltaic Cell: Harvesting Nanotubular Titania and Hybrid Chromophores/CHROMTISOL

Zdrojový dokument

Electrochemistry Communications, vol. 111, February 2020

Vydavatelská verze

https://www.sciencedirect.com/science/article/pii/S1388248120300205

Přístup k e-verzi

Attribution-NonCommercial-NoDerivs 3.0 Czech Republic

Název akce

ISBN

Studijní obor

Studijní program

Signatura tištěné verze

Umístění tištěné verze

Přístup k tištěné verzi

Klíčová slova

TiO2 nanotube layers, Ti spheres, Bipolar Electrochemistry, Photocatalysis

Endorsement

Review

item.page.supplemented

item.page.referenced

Creative Commons license

Except where otherwised noted, this item's license is described as Attribution-NonCommercial-NoDerivs 3.0 Czech Republic